Finally took the tenon off this one. Sycamore, no finish. #woodturning

Looks like beech

Experimenting with ornamental work. Sycamore. #woodturning

Four facets. Sort of square, sort of round. #woodturning

The LatheEngraver using the ornamental turning software i wrote for it. It functions just like a Rose Engine lathe (for much cheaper!)

Sawtooth pattern experiment. #woodturning #ornamentalturning

More facets. These are concave by increasing the relative cut depth. #woodturning #LatheEngraver

Small wooden box with sine waves patterns engraved on the surface

Last #woodturning update is some ornamental sine waves done on the LatheEngraver.

Finally got around to working on this figured maple. Not really a burl, more like a grow-over with some extra bits.

Playing around with modified settings for cutting facets. #woodturning

Five-sided vase. Cherry, dyed, spray lacquer. Of course I dropped it when it was nearly done. #woodturning

Finishing up this scalloped ambrosia maple bowl. #woodturning

So few #woodturning posts on BlueSky. Here is a work in progress. Scalloped ambrosia maple.

Hard to cut that nice a heart on a bandsaw! #woodturning #cnc

Finished up this faceted ambrosia maple bowl. Done with the LatheEngraver. #woodturning #cnc

Finished up the scalloped black walnut. 2.5 hours of cutting on the LatheEngraver and about the same amount of sanding. #woodturning #cnc

Work in progress, 9 scallops on a black walnut bowl. #woodturning

no. It was engraved on the outside, filled with resin, then the inside was turned. you can read more her: www.aawforum.org/community/th...

More LatheEngraver facets. This has some rotation to the facets. #woodturning #cnc

Working out how to cut facets on the LatheEngraver. #woodturning #cnc

I haven't updated that thing in ages. Still requires Blender 2.8 😞

Working on putting the LatheEngraver and my programming skills to the test. This is a piece of American Elm. The interior support is a continuous spiral. #woodturning #cnc

One nice thing about #woodturning is that mistakes are easily erased with some spontaneous oxidation. And a glass of wine. That helps, too.

An old dry piece of Siberian Elm i have had around for a long time. A few pewa to stabilize cracks near the rim. Not the best species to do Beads, but it seemed a bit bland. #woodturning

Haven't done any natural edge bowls in a while. ~12" black cherry. #woodturning

A bit of ambrosia maple on the lathe tonight. There was more curl in it than I had originally thought! #woodturning

A shallow walnut bowl with a little decoration. #woodturning #cnc

Big green piece of beech on the lathe today. Just a bit of spalting. #woodturning

Beyond round (at least at the rim). #woodturning #cnc