The sensor itself doesn't, but built into Home Assistant I can have it displayed on a dashboard, integrated with automations that notify via various channels, and basically do whatever.
SCD40/SCD41 CO2 sensor with an ESP32-C3-SuperMini is awesome! Really compact combo for a room sensor for smart home. I made an enclosure for it, take a look and print one for yourself: makerworld.com/en/models/15... #3dprint #esphome #esp32
Printing some essential band equipment today. Vocalists will only perform with lubrication. #3dprint
Will share the model after some testing and refinement. Needs a bit more reinforcement for the clamps, PETG deforms more than I thought, so it can't be tightened quite as much as I'd like.
No, so far (several weeks) they’ve all reliably ended up down in the bin.
The rear of my P1S isn't accessible the way it's set up, so I printed this two-piece one where the bin ends up on the left side and can be easily taken away and emptied, while the "ramp" stays in place, attached to the printer using existing mounting points. makerworld.com/en/models/41...
Unfortunately, bad news 😅 the interest never fades. It may slow down a bit though, after a while
If you’re in Europe, I can recommend DasFilament XXL spools. Have really good experiences with their PLA and PETG, been using it for years. Matte black and Gold v2 PLAs are extra awesome.
The most organised drawer of cables I’ll never actually need. Putting my new @bambulabglobal.bsky.social P1S to good use. #gridfinity #3dprint
